Basic Model of Hydroelectric Power Station with Turbine. (Modal)
Requirements:
- Spoon 12 number
- A toy car tire large size
- A toy car or tape recorder motor (as a generator)
- Wood with stand
- Metal strip
- Glue
- AVO meter
- LED
Note: you can make a water tank or flow of water system to rotate the turbine from bottles.( we will upload Videos both of with bottle and simple system)
Procedure:
- Fit the entire spoon in the tire by glue as shown in figure, this is the turbine.
- Tight the Generator by metallic strip on wood stand.
- Now fit the turbine in the Generator shaft which is fixed in the wood stand.
- Connect the Volt meter to generator out put terminal wires.
- Now rotate the turbine by hand or fall water by water falling system on the turbine, and see volt meter, it will show some reading. This is the produced electricity. This is hydro power plant system.
Pictorial View of basic hydro power model
Related Articles
-
How to Wire Twin Timer for Repeated ON-Delay in Cycle Mode?
-
Wire Twin Timer in Repeat Cycle & One-Shot Mode for 120V/240V Motors?
-
How to Wire Twin Timer for 120V/240V Circuits – ON/OFF Delay
-
How to Wire Multifunction ON/OFF Delay Timer for 120V/240V Motors?
-
How to Wire One-Shot Timer using Twin Timer For Delay?
-
How to Control 120V & 240V Water Heater using ST01 Timer and Contactors?